SMALL ROUND SANDER REPLACEMENT BULB

Overview

Model: 11367SR

This is the replacement bulb for the SKU 11361SR Inflatable Small Round Sander. There will be occasions when you may need to replace the bulb. The most common examples are listed here.

1. Sometimes when the flange or nut comes in contact with the rubber, if old, the rubber may crack and no longer hold air.
2. The bulb could also puncture if you’re sanding and hit a splinter.
3. When you believe the sander no longer holds air but cannot pinpoint the source, we recommend you inflate the bulb full of air and submerge it in a basin/receptacle of water.  If punctured, the bubbles will show the source of the leak.
4. If bubbles are coming through the hollow shaft, dust has collected between the rubber tube or collar (yellow) that covers the air hole on the shaft inside the sander. Usually, you only have to clean the rubber bulb and shaft, and not replace the bulb. To clean, remove the bulb, roll back half (½) of the rubber tube on the shaft, rinse gently with water, and roll the tube back over the shaft. Then repeat and clean the other end.

WHAT'S INCLUDED

SKU 11361SR Small Round Sander Replacement Bulb

REPLACEMENT SANDING SLEEVES

Small Round Sanding Sleeves - Available in 80g, 120g, 320g and Assorted Grits

DOCUMENTS

Guinevere Instructions and FAQ (p.10) [PDF]